House Extension Drawings in Brixton |

An Article 4 Direction applies across Lambeth, so check it before assuming Brixton permitted development survives. Being Victorian terraces, vibrant centre, Brixton rewards schemes that sit quietly beside Brixton Market. Lambeth carries 64 conservation areas; if the SW2 address falls in Herne Hill or Brixton Road, expect the permitted-development route to close and a full Lambeth Council application to be the faster answer. A Brixton address on the edge of the boundary is checked, not guessed.

Knowing how Article 4 directions apply to your SW2 address is the first thing we establish. On Brixton stock the constraint is physical before it is planning: the victorian terraces fixes the rear wall line and the Brixton Market roofline caps the ridge. The borough policy layer over every SW2, SW9 address is set out on Lambeth planning. The Brixton survey then carries into building regulations drawings in Brixton if the project runs on to construction.

Most Brixton delay happens before the clock starts: London Borough of Lambeth takes one to two weeks to validate, and an incomplete pack goes to the back of the queue. No Brixton design work starts until the measured survey is complete.

Statutory periods: 8 weeks from validation for a householder application, 13 weeks for a major scheme, 6 weeks for prior approval with a 21 days neighbour consultation, and 5 weeks for a full plans building control submission. A party structure notice requires one month notice and two months where excavation is involved.

Amendments during the Brixton determination are handled without a resubmission where possible. Every Brixton submission leaves here as a PDF set at the scales Lambeth Council requires.

Objection volume on Brixton cases is public — we read it before advising. We photograph the Brixton property alongside the measurements for the record.

Budget notice time on any Brixton job touching a shared wall. Once consent is granted, loft conversion drawings follows for the SW2 property.

Brixton is characterised by victorian terraces, post-war estates, concentrated across SW2, SW9 in the Brixton Hill / Tulse Hill area. The victorian terraces is the constraint that shapes most Brixton projects, long before policy enters the picture. On SW2 plots specifically, the side-return infill is the classic move on these Victorian terraces — 3 m of permitted development depth plus the width of the original side passage. That is the Brixton constraint Lambeth Council will look for. Because the Brixton streetscape near Brixton Market is consistent, departures in ridge height read immediately in an officer report.

No borough-specific basement policy applies in Lambeth, so subterranean work at a Brixton address is judged on amenity, drainage and structural grounds. One Brixton survey serves architectural drawings for SW2 properties and planning permission too; we do not re-measure a SW2 property for each submission.

What the Brixton drawing pack contains

The drawing schedule for a Brixton project runs as follows.

• existing and proposed ground-floor plans for the Brixton property
• proposed rear elevation
• long section through the extension
• site and block plans
• party wall position drawing

Streets and landmarks we survey around Brixton

• Brick Lane — terraced rear elevations — the Brick Lane party wall position is drawn first.
• Brockwell Park — terraced rear elevations — the Brockwell Park party wall position is drawn first.
• Tulse Hill — closet wings that change how a rear extension meets the Tulse Hill back addition.
• Herne Hill — side returns where the 45-degree amenity test decides how far a Herne Hill extension goes.
• Brixton Hill — side returns where the 45-degree amenity test decides how far a Brixton Hill extension goes.
• Brixton Road — closet wings that change how a rear extension meets the Brixton Road back addition.
• Coldharbour Lane — side returns where the 45-degree amenity test decides how far a Coldharbour Lane extension goes.
• Windrush Square — side returns where the 45-degree amenity test decides how far a Windrush Square extension goes.
• Brixton Market — sightlines from here are part of the Lambeth Council character assessment.
• Electric Avenue — Lambeth Council weighs SW2 sightlines to it in the character assessment.
• Brixton Academy — height and massing nearby are argued against this frontage.
• Brixton Market — sightlines from here are part of the Lambeth Council character assessment.
• Vauxhall Bridge — proposals within its setting are drawn with the context elevation included.
• Rush Common — a Brixton roof extension is judged against the datum it sets.

Getting to a Brixton survey

Surveyors travel to SW2 addresses from the studio; the nearest stations are Brixton, Brixton and South Stockwell, Loughborough Park, File:Brixton. Appointments are booked in Brixton on weekdays and Saturdays, and the measured survey of a standard victorian terraces takes two to three hours.

Where Brixton sits

on Ordnance Survey grid reference TQ315755, inside the Clapham and Brixton Hill parliamentary constituency. We draw the Brixton location and block plans from that reference, which is what Lambeth Council validates against. Source.

Practical detail for a Brixton submission: we reach Brixton sites via Brixton and Brixton and South Stockwell and Loughborough Park and File:Brixton; LONDON is the post town on Brixton addresses; dialling code 020; Grade II* Beresford Pite carry listed status close to SW2 sites. Site plans are drawn to the address as Lambeth Council holds it.

Brixton postcode coverage

Our Brixton coverage takes in SW2 (Brixton Hill / Tulse Hill), shared with Tulse Hill; SW9 (Brixton / Stockwell), shared with Stockwell.

Streets and stations in Brixton

Brick Lane, Brockwell Park, Tulse Hill, Herne Hill, Brixton Hill, Brixton Road, Coldharbour Lane and Windrush Square are typical of the Brixton streets we draw. most Brixton sites are within walking distance of Brixton or Brixton and South Stockwell or Loughborough Park. and Grade II* Beresford Pite is listed, which pulls neighbouring SW2 proposals into a setting assessment.

Areas we cover around Brixton

Neighbouring coverage runs to Tonsleys (SW18), Nightingale Triangle (SW12), Roehampton (SW15), Croydon (CR0), Crystal Palace (SE19), Upper Norwood (SE19); the Lambeth policy is shared but the stock and the designations are not.

The variables on a SW2 job are structural: party walls, floor levels, and whether the Herne Hill designation adds a heritage statement.

Statutory application fees are set by regulation, not by the council: £548 householder, £610 for a new dwelling, £274 for a lawful development certificate, £249 for prior approval.

Those statutory fees go to London Borough of Lambeth on submission. London planning approval-rate dataset · Lambeth planning · house extension drawings in London · house extension drawings in Tonsleys.

A chartered technologist surveys the Brixton property and signs the drawings — the same person, start to finish. We would rather spend on Lambeth Council advice than lose a Brixton decision and resubmit.

Drawings are produced by chartered members of the Chartered Institute of Architectural Technologists (MCIAT), the professional body for technical design and building-regulations competence. First-time approval across our London caseload is 98%. Statutory fees shown are those in force in England in 2026 under the Town and Country Planning (Fees for Applications) Regulations. Confirm your local authority at gov.uk and submission requirements on the Planning Portal. Studio: 71–75 Shelton Street, London WC2H 9JQ.

Book the Brixton survey and the drawings follow within the agreed programme. This Brixton page was reviewed in August 2026.